Electrochemical CO 2 Capture by a Quinone-Based Covalent Organic Framework

Muhammad Abdullah Khan, Zhen Xu, Muhammad Muzammil, S.p. Bird, Munawar Ali Munawar, Fariah Salam, Niamh A. Hartley, Jack Taylor, Kamran Amin, Jianheng Ling, Henry R. N. B. Enninful, Naveed Zafar Ali, Kai Hetze, Sijia Cao, Yan Lü, Zhixiang Wei, Martin Oschatz, Phillip J. Milner, Alexander C. ForseJournal of the American Chemical Society 2025 · DOI

TL;DR

Researchers have developed a novel covalent organic framework (COF) material that electrochemically captures CO2 with high efficiency and stability, particularly in aqueous electrolytes. This breakthrough offers a promising, energy-efficient alternative to traditional CO2 capture methods, paving the way for more sustainable carbon capture technologies.

What Problem Does This Paper Address?

The urgent need to mitigate climate change necessitates efficient and cost-effective methods for capturing carbon dioxide (CO2). Traditional CO2 capture technologies, such as thermal and pressure-swing processes, are often energy-intensive and can be expensive. Electrochemical CO2 capture (eCC) has emerged as a promising alternative, offering the potential for lower energy consumption by utilizing electrical energy to drive CO2 capture and release. However, existing eCC systems face challenges related to low CO2 uptake capacities, poor long-term stability, and difficulties in integrating capture materials into practical devices. Specifically, previous attempts to use redox-active molecules like anthraquinones (AQs) grafted onto carbon supports have suffered from limited CO2 capacity and rapid degradation. This paper aims to address these limitations by designing and testing a well-defined, porous anthraquinone-based covalent organic framework (AQCOF) as an electrode material for eCC.

Methods

The researchers synthesized an anthraquinone-based covalent organic framework (AQCOF) and then further modified it by incorporating carbon nanotubes (CNTs) to improve its conductivity and charge capacity, creating AQCOF@CNTs. This material was then used as the working electrode in a two-electrode electrochemical cell.

Key experimental techniques included:

  • Electrochemical Measurements: Galvanostatic charge-discharge cycles and cyclic voltammetry (CV) were employed to assess CO2 capture and release, charge storage, and the electrochemical behavior of the AQCOF@CNTs.
  • CO2 Pressure Monitoring: A pressure sensor was used to directly monitor the change in CO2 pressure within the sealed electrochemical cell, indicating CO2 uptake and release.
  • Material Characterization: While not detailed in the main text, the Supporting Information mentions synthesis and characterization of the AQCOF, implying techniques like NMR, FTIR, and BET surface area analysis were used.
  • Electrolyte Variations: The study systematically compared the performance of the AQCOF@CNTs in both ionic liquid (IL) electrolytes ([Bmim][TFSI]) and aqueous electrolytes (1 M Na2SO4).
  • Gas Mixture Testing: Experiments were conducted with pure CO2, CO2/N2 mixtures, and CO2/O2 mixtures to evaluate selectivity and the impact of oxygen.
  • Chemical Reduction and FTIR: To confirm the capture mechanism, the AQCOF was chemically reduced, and its FTIR spectra were analyzed before and after CO2 dosing to identify the formation of carbonate species.

Datasets

Not discussed in the paper.

Key Insights and Ideas

  • COFs as a Platform for eCC: This work demonstrates for the first time that covalent organic frameworks can serve as effective electrode materials for electrochemical CO2 capture, offering a new class of materials for this application.
  • Direct Redox Capture Mechanism: The study provides strong evidence for a direct redox capture mechanism where reduced anthraquinone units in the COF electrochemically bind CO2. This is supported by FTIR data showing the formation of carbonate species upon CO2 dosing of reduced AQCOF.
  • Aqueous Electrolytes are Superior: While ionic liquids showed initial promise, aqueous electrolytes (specifically 1 M Na2SO4) significantly outperform ILs in terms of CO2 uptake capacity, rate, and, most importantly, long-term stability.
  • CNT Integration is Crucial: The incorporation of carbon nanotubes into the AQCOF structure (AQCOF@CNTs) dramatically improved charge storage and accessibility of redox sites, overcoming limitations of isolated AQ units.
  • pH Swing Contribution in Aqueous Media: In aqueous electrolytes, a combination of direct redox capture and a pH swing mechanism likely contributes to CO2 uptake, although the direct redox mechanism appears dominant.

Key Results

  • High CO2 Uptake Capacity: The AQCOF@CNTs achieved a CO2 uptake capacity of ~2.6 mmol g⁻¹ in an ionic liquid electrolyte at 5 mA g⁻¹, which is the highest reported for capacitive or redox eCC systems.
  • Improved Stability in Aqueous Electrolytes: In 1 M Na2SO4, the system demonstrated remarkable stability, maintaining capture for 500 cycles with a 99.6% Coulombic efficiency.
  • Low Energy Consumption: The aqueous system achieved an electrical energy consumption of 31 kJ mol⁻¹ CO₂, significantly lower than traditional thermal methods.
  • Mechanism Confirmation: FTIR analysis of chemically reduced AQCOF after CO2 dosing showed characteristic peaks confirming the formation of carbonate species, supporting the direct redox capture mechanism.
  • Oxygen Sensitivity: The AQCOF@CNTs showed reduced performance and Coulombic efficiency in the presence of oxygen, highlighting a challenge for real-world applications.

Limitations and Future Work

  • Oxygen Sensitivity: The observed sensitivity to oxygen is a significant limitation for capturing CO2 from flue gas or ambient air. Future work should focus on developing redox-active COFs with higher redox potentials or utilizing stabilizing interactions to mitigate this issue.
  • Mechanism Clarification: While direct redox capture is strongly supported, the exact interplay of mechanisms, particularly the pH swing in aqueous electrolytes, requires further in-depth study.
  • Long-Term Stability in Real Gas Mixtures: While stable in pure CO2, performance in complex flue gas mixtures (containing SOx, NOx) needs to be investigated.
  • Scale-Up and Techno-Economic Analysis: The authors suggest that future work should include life cycle assessments and techno-economic analyses to evaluate the sustainability and economic viability of using COFs for electrochemical separations.
  • Electrode Degradation: Post-cycling analysis revealed some structural and mechanical degradation, particularly in ionic liquid electrolytes, which needs to be addressed for long-term industrial application.

Summary updated

Abstract

Electrochemical CO<sub>2</sub> capture is an emerging technology that promises to be more energy-efficient than traditional thermal or pressure-swing processes. Herein, the first evidence of electrochemical capture of CO<sub>2</sub> using a covalent organic framework (COF) is presented. We hypothesized that the assembly of anthraquinone units into a well-defined porous framework electrode would lead to enhanced electrochemical CO<sub>2</sub> capture compared to previous approaches that grafted anthraquinones on carbon supports and suffered from low CO<sub>2</sub> capacities and stabilities. To test this, an anthraquinone-based COF is employed, and it is found that the quinones are electrochemically accessible for reversible CO<sub>2</sub> capture in an ionic liquid electrolyte. The system achieves a high electrochemical CO<sub>2</sub> uptake capacity >2.6 mmol g<sup>-1</sup> COF, reaching half of the theoretical CO<sub>2</sub> capacity of the material and surpassing the capacities of anthraquinone-functionalized carbons. The stability and CO<sub>2</sub> uptake rate issues encountered with the ionic liquid system are also addressed by using aqueous electrolytes where we attained stable carbon capture for 500 cycles with a 99.6% Coulombic efficiency and an electrical energy consumption of 31 kJ mol<sub>CO<sub>2</sub></sub><sup>-1</sup>. The use of covalent organic framework electrodes can become a general strategy for understanding and enhancing the electrochemical CO<sub>2</sub> capture.
BibTeX
@article{khan2025electrochemical,
  author = {Muhammad Abdullah Khan and Zhen Xu and Muhammad Muzammil and S.P. Bird and Munawar Ali Munawar and Fariah Salam and Niamh A. Hartley and Jack Taylor and Kamran Amin and Jianheng Ling and Henry R. N. B. Enninful and Naveed Zafar Ali and Kai Hetze and Sijia Cao and Yan Lü and Zhixiang Wei and Martin Oschatz and Phillip J. Milner and Alexander C. Forse},
  title = {{Electrochemical CO <sub>2</sub> Capture by a Quinone-Based Covalent Organic Framework}},
  journal = {Journal of the American Chemical Society},
  year = {2025},
  doi = {10.1021/jacs.5c12304},
}
Figure