Effects of Ca2+ and fulvic acids on atrazine degradation by nano-TiO2: Performances and mechanisms

Saiwu Sun, Huijun He, Chunping Yang, Yan Cheng, Yongpan LiuScientific 2019 · DOI

TL;DR

This study investigates how calcium ions (Ca²⁺) and fulvic acids (FA) affect the removal of the pesticide atrazine using nano-titanium dioxide (nano-TiO₂) under UV irradiation. The key finding is that both Ca²⁺ and FA hinder atrazine degradation by causing nano-TiO₂ particles to aggregate, reducing their surface area and photocatalytic efficiency.

What Problem Does This Paper Address?

Atrazine is a widely used herbicide that poses environmental and health risks due to its persistence and potential for bioaccumulation. While photocatalysis with nano-TiO₂ is a promising method for its removal, real-world water sources are complex mixtures containing various ions and organic matter. This study addresses the critical gap in understanding how common water constituents like Ca²⁺ and fulvic acids (a major component of natural organic matter) influence the effectiveness of nano-TiO₂ photocatalysis for atrazine degradation. Specifically, it aims to elucidate the mechanisms behind these influences, which are not fully understood.

Methods

The researchers employed a combination of experimental techniques to assess atrazine removal and the behavior of nano-TiO₂:

  • Photocatalytic Degradation Experiments: Atrazine degradation was measured over time under UV irradiation in the presence of nano-TiO₂ and varying concentrations of Ca²⁺ (added as CaCl₂) and/or FA. Experiments were conducted in two phases: a dark period for adsorption and a UV irradiation period for photocatalysis.
  • Colloidal Stability Analysis: To understand how Ca²⁺ and FA affect the nano-TiO₂ particles themselves, several characterization techniques were used:
  • Scanning Electron Microscopy (SEM): Visualized the aggregation state of nano-TiO₂ particles under different conditions.
  • Dynamic Light Scattering (DLS) for Hydrodynamic Diameter (HDD): Measured the average size of particle aggregates in suspension.
  • Zeta Potential Measurement: Assessed the surface charge of the nanoparticles, which influences their stability and tendency to aggregate.
  • Sedimentation Experiments: Monitored the rate at which nano-TiO₂ particles settled out of solution, indicating their colloidal stability.
  • Characterization of Nano-TiO₂: Standard techniques like FT-IR and XRD were used to confirm the properties of the commercial nano-TiO₂.

Datasets

Not discussed in the paper. The study utilized prepared solutions of atrazine, nano-TiO₂, CaCl₂, and FA under controlled laboratory conditions.

Key Insights and Ideas

  • Aggregation is the Primary Culprit: The most significant insight is that both Ca²⁺ and FA independently and synergistically promote the aggregation of nano-TiO₂ particles. This aggregation is the primary reason for the reduced photocatalytic efficiency.
  • Surface Area Matters: Aggregation directly leads to a decrease in the effective surface area of nano-TiO₂ available for adsorption and photocatalytic reactions, thus slowing down atrazine removal.
  • Competitive Adsorption: Fulvic acids not only cause aggregation but also compete with atrazine for active adsorption sites on the nano-TiO₂ surface, further hindering the removal process.
  • Ca²⁺ as a "Bridge": Ca²⁺ ions are hypothesized to act as "bridges" between negatively charged nano-TiO₂ particles (at pH 7.0), facilitating their aggregation.
  • Sedimentation as an Indicator: The rate of nano-TiO₂ sedimentation directly correlates with its colloidal stability and, consequently, with the photocatalytic degradation efficiency. Faster sedimentation implies poorer stability and lower efficiency.
  • Mg²⁺ vs. Ca²⁺: The study briefly touches upon Mg²⁺, suggesting that its effect on aggregation and photocatalysis might differ from Ca²⁺, hinting at the specific ionic properties playing a role.

Key Results

  • Adsorption Inhibition: The adsorption of atrazine onto nano-TiO₂ decreased significantly with increasing concentrations of Ca²⁺ and FA. For instance, without Ca²⁺, atrazine removal in the dark was 49.2%, dropping to 7.6% with 100 mmol/L CaCl₂.
  • Photocatalytic Degradation Reduction: The photocatalytic degradation efficiency of atrazine was also substantially reduced by Ca²⁺ and FA. In the absence of CaCl₂, atrazine was completely degraded within 2 hours of UV irradiation. With 100 mmol/L CaCl₂, 38.9% of atrazine remained after 2 hours.
  • Aggregation Confirmation: SEM images visually confirmed the aggregation of nano-TiO₂ particles, with larger agglomerates observed at higher Ca²⁺ and FA concentrations. DLS measurements showed an increase in hydrodynamic diameter with increasing Ca²⁺ and FA.
  • Zeta Potential Shift: Zeta potential measurements indicated a shift towards less negative or even slightly positive values with increasing Ca²⁺, suggesting a reduction in electrostatic repulsion between particles and promoting aggregation.
  • Sedimentation Kinetics: Sedimentation was fastest in the coexistent Ca²⁺-FA system, followed by Ca²⁺ alone, mirroring the trends observed in photocatalytic degradation efficiency.

Limitations and Future Work

  • Limited Scope of Ions/Organics: The study focused on Ca²⁺ and FA. Real water matrices contain a much wider array of ions (e.g., Mg²⁺, K⁺, Na⁺, Cl⁻, SO₄²⁻) and organic matter (e.g., humic acids, proteins). The interactions with these other components are not explored.
  • Specific Atrazine Concentration: The study used a single atrazine concentration. The effect of varying atrazine concentrations in conjunction with Ca²⁺ and FA could be further investigated.
  • Mechanism of FA Quenching: While FA's role in aggregation and competitive adsorption is discussed, its potential to directly quench hydroxyl radicals (as suggested by other studies) is mentioned but not deeply explored.
  • Future Work Suggestions: The authors suggest that understanding the combined effects of Ca²⁺ and FA on colloidal stability is crucial for predicting nano-TiO₂ performance in natural water. Further research could explore modified nano-TiO₂ materials or alternative treatment strategies that are more resilient to these water matrix effects. Investigating the specific roles of different components within FA and their interactions with Ca²⁺ could also be beneficial.

Summary updated

Abstract

In this study, the adsorption and UV photocatalytic degradation of atrazine using nano-TiO<sub>2</sub> particles were studied systematically, and the colloidal stability of nano-TiO<sub>2</sub> particles in solution was also investigated to reveal the removal mechanism. Experiments which contained the first 6.0 hours darkness and 4.0 hours UV illumination later were conducted at different concentrations of Ca<sup>2+</sup> and/or fulvic acids (FA) at pH = 7.0. Results showed that the adsorption rate of atrazine onto nano-TiO<sub>2</sub> particles decreased with the increase of Ca<sup>2+</sup> and/or FA concentrations, which could be explained well by the colloidal stability of nanoparticles. When the solution contained Ca<sup>2+</sup> or Ca<sup>2+</sup>-FA, the nanoparticles were aggregated together leading to the decrease of the contact surface area. Besides, there existed competitive adsorption between FA and atrazine on the particle surface. During photocatalytic degradation, the increase of Ca<sup>2+</sup> and/or FA concentration accelerated the aggregation of nano-TiO<sub>2</sub> particles and that reduced the degradation efficiency of atrazine. The particle sizes by SEM were in accordance with the aggregation degree of nanoparticles in the solutions. Sedimentation experiments of nano-TiO<sub>2</sub> particles displayed that the fastest sedimentation was happened in the CaCl<sub>2</sub> and FA coexistent system and followed by CaCl<sub>2</sub> alone, and the results well demonstrated the photodegradation efficiency trends of atrazine by nano-TiO<sub>2</sub> particles under the different sedimentation conditions.
BibTeX
@inproceedings{sun2019effects,
  author = {Saiwu Sun and Huijun He and Chunping Yang and Yan Cheng and Yongpan Liu},
  title = {{Effects of Ca2+ and fulvic acids on atrazine degradation by nano-TiO2: Performances and mechanisms}},
  booktitle = {Scientific},
  year = {2019},
  doi = {10.1038/s41598-019-45086-2},
}
Figure