Dynamic evolution of the fractures and hydraulic pressures in water-resistant strata between karst cavity and tunnel based on discrete element method

Zhenyu He, Jiaqi Guo, Fan ChenProceedings of the 2017 3rd International Forum on Energy, Environment Science and Materials (IFEESM 2017) 2018 · DOI

Abstract

Based on the discrete element software (UDEC), the variation laws of the seepage field and displacement field in water-resistant strata between karst cavity with high-pressuried water and tunnel are simulated and analyzed in thin limestone strata. The results show that under the same karst water pressure, when the thickness of water-resistant strata is 2m, the water-resistant strata is in the whole collapse tendency and the water-inrush channels are formed in a short time, but when the thickness of water-resistant strata is 4m, the rock mass in the 1m range above the tunnel vault is slumped to form a collapse arch, which is less prone to water-inrush.

Introduction

In karst landscapes, underground cavities filled with high-pressure water pose a significant risk to deep-tunnel infrastructure. As construction expands into these regions, engineers frequently encounter concealed karst caves. The primary hazard is water-inrush: a sudden, violent flood into the tunnel caused by the structural failure of the water-resistant strata—the rock wall separating the tunnel from the cavity. While previous research has focused on static stability, this study investigates the dynamic evolution of fractures and hydraulic pressure shifts in real-time as the rock barrier fails.

Methodology

The researchers employed the Discrete Element Method (DEM) using the Universal Discrete Element Code (UDEC) software. Unlike traditional continuum mechanics, DEM treats rock as a collection of discrete blocks separated by joints and fissures. This approach is essential for tracking fracture propagation—how individual rock blocks shift, rotate, and detach—and fluid-solid coupling, where high-pressure water seeps into opening cracks, further weakening the rock.

The study modeled a tunnel at a depth of 500m with an elliptical karst cavity located directly above it. Four scenarios were tested by varying two primary parameters:

  • Strata Thickness ($d$): 2 meters vs. 4 meters.
  • Water Pressure ($p$): 2 MPa vs. 5 MPa.
The numerical model setup and arrangement of monitoring points for different strata thicknesses.

Results and Discussion

The "Collapse Arch" Phenomenon

A critical finding of the simulation is that doubling the strata thickness from 2m to 4m fundamentally changes the failure mechanics. At a thickness of 4m, the rock forms a "collapse arch." Only the first meter of rock above the tunnel vault slumps, while the remaining rock bridges the gap, maintaining a seal against the high-pressure water. In contrast, the 2m strata exhibited a "whole collapse tendency," where water-inrush channels formed almost immediately (under 10 seconds in simulation time).

Influence of Water Pressure

While increasing water pressure from 2 MPa to 5 MPa accelerated the failure process, it did not alter the fundamental failure mode. Strata thickness remained the primary determinant of whether a catastrophic water-inrush channel formed. The simulation captured a dangerous feedback loop: as the rock deforms, water pressure enters the newly formed fractures, acting as a wedge that drives the cracks further open until the wall gives way.

UDEC simulation results showing displacement contours, fracture propagation, and quantitative data for displacement, pressure, and flow rate.

Quantitative Analysis

Recording points within the model showed that in the 2m cases, flow rates and displacement curves spiked sharply and simultaneously, signaling a sudden breach. In the 4m cases, these curves remained significantly more stable, confirming the protective effect of the collapse arch.

Conclusion

This study demonstrates that the thickness of the water-resistant strata is the deciding factor between manageable localized rockfall and catastrophic water-inrush. While this 2D model provides vital insights into the dynamic evolution of failure, future work should explore irregular 3D geometries and the impact of engineering reinforcements like liners and grouting. Understanding these dynamic processes is critical for predicting and preventing fatal construction accidents in karst regions.

Summary updated

Abstract

Based on the discrete element software (UDEC), the variation laws of the seepage field and displacement field in water-resistant strata between karst cavity with high-pressuried water and tunnel are simulated and analyzed in thin limestone strata. The results show that under the same karst water pressure, when the thickness of water-resistant strata is 2m, the water-resistant strata is in the whole collapse tendency and the water-inrush channels are formed in a short time, but when the thickness of water-resistant strata is 4m, the rock mass in the 1m range above the tunnel vault is slumped to form a collapse arch, which is less prone to water-inrush.
BibTeX
@inproceedings{he2018dynamic,
  author = {Zhenyu He and Jiaqi Guo and Fan Chen},
  title = {{Dynamic evolution of the fractures and hydraulic pressures in water-resistant strata between karst cavity and tunnel based on discrete element method}},
  booktitle = {Proceedings of the 2017 3rd International Forum on Energy, Environment Science and Materials (IFEESM 2017)},
  year = {2018},
  doi = {10.2991/ifeesm-17.2018.2},
}
Figure