COVID-19 Pandemic Outbreak in the Subcontinent: A data-driven analysis

Bikash Chandra Singh, Md. Zulfikar Alom, Mohammad Muntasir Rahman, Mrinal Kanti Baowaly, Mohammad Abdul AzimarXiv 2020 · OpenReview

Abstract

Human civilization is experiencing a critical situation that presents itself for a new coronavirus disease 2019 (COVID-19). This virus emerged in late December 2019 in Wuhan city, Hubei, China. The grim fact of COVID-19 is, it is highly contagious in nature, therefore, spreads rapidly all over the world and causes severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2). Responding to the severity of COVID-19 research community directs the attention to the analysis of COVID-19, to diminish its antagonistic impact towards society. Numerous studies claim that the subcontinent, i.e., Bangladesh, India, and Pakistan, could remain in the worst affected region by the COVID-19. In order to prevent the spread of COVID-19, it is important to predict the trend of COVID-19 beforehand the planning of effective control strategies. Fundamentally, the idea is to dependably estimate the reproduction number to judge the spread rate of COVID-19 in a particular region. Consequently, this paper uses publicly available epidemiological data of Bangladesh, India, and Pakistan to estimate the reproduction numbers. More specifically, we use various models (for example, susceptible infection recovery (SIR), exponential growth (EG), sequential Bayesian (SB), maximum likelihood (ML) and time dependent (TD)) to estimate the reproduction numbers and observe the model fitness in the corresponding data set. Experimental results show that the reproduction numbers produced by these models are greater than 1.2 (approximately) indicates that COVID-19 is gradually spreading in the subcontinent.

Introduction

The COVID-19 pandemic has posed an unprecedented challenge to global health systems. In the densely populated regions of the South Asian subcontinent—specifically Bangladesh, India, and Pakistan—the potential for rapid transmission is particularly high. To implement effective public health interventions, it is crucial to understand the transmission dynamics, often summarized by the basic reproduction number ($R_0$). This paper provides a comparative, data-driven analysis of the outbreak's early stages in these three nations, utilizing multiple epidemiological models to ensure robust findings.

Methodology and Data Sources

The study utilized publicly available epidemiological data from the Johns Hopkins University Center for Systems Science and Engineering (JHU CCSE), covering daily confirmed cases, deaths, and recoveries from the onset of the pandemic in each country through June 19, 2020.

To estimate the reproduction number, five distinct mathematical frameworks were employed:

  1. SIR (Susceptible-Infectious-Recovered): A compartmental model tracking population transitions through disease stages.
  2. Exponential Growth (EG): Focuses on the initial growth rate to determine invasion speed.
  3. Sequential Bayesian (SB): A probabilistic approach that updates $R_0$ estimates as new data becomes available.
  4. Maximum Likelihood (ML): Estimates $R_0$ assuming secondary cases follow a Poisson distribution.
  5. Time-Dependent (TD): Provides a dynamic view of transmission rates over time.

Comparative Analysis of Testing and Spread

A significant factor in interpreting case counts is the testing capacity of each nation. The analysis revealed a "testing gap" where India, despite having the highest absolute case numbers, also maintained the highest testing rate per million people among the three countries. This suggests that lower reported case numbers in Bangladesh and Pakistan may be partially attributed to lower testing volumes rather than lower prevalence.

Comparison of COVID-19 testing rates per million people across Bangladesh, India, and Pakistan.

Modeling Results and Projections

The multi-model approach yielded a consensus: the reproduction number $R_0$ remained consistently above 1.2 across all three countries. Specifically, the SIR model estimated $R_0$ values of 1.234 for Bangladesh, 1.197 for India, and 1.22 for Pakistan. More dynamic models, such as the Time-Dependent (TD) approach, suggested even higher mean reproduction numbers, reaching up to 1.774 in Pakistan.

The SIR model was also used to project the pandemic's trajectory. Based on data available through June 2020, the models predicted a peak in infections by early August 2020, assuming no significant changes in transmission rates or intervention strategies.

SIR model projection showing the progression of susceptible, observed, recovered, and infectious populations.

Conclusion

The analysis confirms that COVID-19 was spreading steadily across the subcontinent during the first half of 2020, with $R_0$ values indicating that initial containment measures were insufficient. The study also highlights the critical role of testing capacity in pandemic monitoring. Future research should incorporate more granular demographic data and account for super-spreader events to further refine these epidemiological predictions.

Summary updated

Abstract

Human civilization is experiencing a critical situation that presents itself for a new coronavirus disease 2019 (COVID-19). This virus emerged in late December 2019 in Wuhan city, Hubei, China. The grim fact of COVID-19 is, it is highly contagious in nature, therefore, spreads rapidly all over the world and causes severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2). Responding to the severity of COVID-19 research community directs the attention to the analysis of COVID-19, to diminish its antagonistic impact towards society. Numerous studies claim that the subcontinent, i.e., Bangladesh, India, and Pakistan, could remain in the worst affected region by the COVID-19. In order to prevent the spread of COVID-19, it is important to predict the trend of COVID-19 beforehand the planning of effective control strategies. Fundamentally, the idea is to dependably estimate the reproduction number to judge the spread rate of COVID-19 in a particular region. Consequently, this paper uses publicly available epidemiological data of Bangladesh, India, and Pakistan to estimate the reproduction numbers. More specifically, we use various models (for example, susceptible infection recovery (SIR), exponential growth (EG), sequential Bayesian (SB), maximum likelihood (ML) and time dependent (TD)) to estimate the reproduction numbers and observe the model fitness in the corresponding data set. Experimental results show that the reproduction numbers produced by these models are greater than 1.2 (approximately) indicates that COVID-19 is gradually spreading in the subcontinent.
BibTeX
@misc{singh2020covid,
  author = {Bikash Chandra Singh and Md. Zulfikar Alom and Mohammad Muntasir Rahman and Mrinal Kanti Baowaly and Mohammad Abdul Azim},
  title = {{COVID-19 Pandemic Outbreak in the Subcontinent: A data-driven analysis}},
  year = {2020},
  eprint = {2008.09803},
  archivePrefix = {arXiv},
  url = {https://arxiv.org/abs/2008.09803},
}
Figure