Comparison of the H.263 and H.261 video compression standards

Bernd Girod, Eckehard Steinbach, Niko FaerberProceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE 1995 · DOI

Abstract

The draft international standard ITU-T H.263 is closely related to the well known and widely used ITU-T Recommendation H.261. However, H.263 does provide the same subjective image quality at less than half the bit-rate. In this paper we investigate to what extend single enhancements of H.263 contribute to this performance gain, and consider the trade-off quality vs. complexity. Based on the test sequence “Foreman”, H.263 in its default- and optional codingmodes is compared to H.261 on the basis of rate distortion curves at bit-rates up to 128 kbps. At 64 kbps, the performance gain of H.263 in its default mode compared to H.261 is approximately 2 dB PSNR. This improvement is achieved with only little increase of complexity, and is mainly due to more accurate motion compensation with half-pel accuracy. Considering the trade-off quality vs. complexity, the combination of the optional coding-modes “Advanced prediction mode” and “PB-frames mode” seems to be a good compromise, resulting in an additional performance gain of 1 dB PSNR at 64 kbps. The “Syntax-based arithmetic coding mode” on the other hand, offers only a very small performance gain (0.2 dB PSNR at 64 kbps) for its increased computational complexity. Results from profiling a H.263 software codec are presented in order to support complexity considerations of the optional coding-modes.
BibTeX
@inproceedings{girod1995comparison,
  author = {Bernd Girod and Eckehard Steinbach and Niko Faerber},
  title = {{Comparison of the H.263 and H.261 video compression standards}},
  booktitle = {Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE},
  year = {1995},
  doi = {10.1117/12.227952},
}

Loading related content...

Figure