Channel-Aware Ordered Successive Relaying with Finite-Blocklength Coding

Lingrui Zhang, Yuxing Han, Qiong Wang, Wei ChenarXiv 2022 · DOI · arXiv

Abstract

This paper introduces CAO-SIR-FBC, a novel relaying protocol designed to meet the ultra-reliable, low-latency communication (URLLC) requirements of 6G networks. By integrating successive relaying with finite-blocklength coding (FBC) and channel-aware ordering, the proposed protocol overcomes the "short packet" penalty and inter-relay interference (IRI). Simulation results demonstrate that CAO-SIR-FBC achieves significantly higher spectral efficiency and multiplexing gains compared to traditional half-duplex relaying schemes.

Introduction

The evolution toward 6G necessitates URLLC for mission-critical applications such as autonomous driving and telesurgery. To minimize latency, these systems must utilize very short data packets. However, traditional information theory based on Shannon’s capacity assumes infinite blocklengths. In the Finite Blocklength (FBC) regime, a significant "coding gain loss" occurs, meaning reliable transmission rates are lower than Shannon's predictions.

While Successive Relaying (SR) can boost transmission rates by allowing multiple relays to transmit simultaneously, it introduces Inter-Relay Interference (IRI). Managing this interference is particularly challenging with short packets, where a single decoding error can propagate and compromise the entire system's reliability.

System Architecture and Methodology

The authors propose Channel-Aware Ordered Successive Relaying with Finite-Blocklength Coding (CAO-SIR-FBC) to balance high-speed relaying with strict reliability constraints.

Figure 1: System model of the proposed CAO-SIR-FBC protocol featuring a source (S), destination (D), and N ordered relays.

The protocol employs several key technical strategies:

  1. Successive Decode-and-Forward (DF): Relays decode messages from the source and forward them in a staggered fashion to recover the multiplexing loss inherent in standard half-duplex systems.
  2. Channel-Aware Ordering: Relays are ordered based on their channel gains ($g_{S,1} \leq g_{S,2} \dots$) to systematically mitigate IRI.
  3. Rate Adaptation Optimization: The system maximizes the transmission rate while maintaining a total error probability below a strict threshold (e.g., $10^{-3}$).
  4. Convex Optimization: To solve the initially non-convex optimization problem, the authors utilize mathematical transformations and a Bisection Algorithm to find optimal transmission rates in real-time.

Key Results and Performance

The protocol was evaluated using both i.i.d. Rayleigh fading channels and more realistic i.n.i.d. models incorporating path loss.

Figure 3: Average throughput vs. transmitter-side SNR for i.i.d. Rayleigh fading, showing the 4.0 dB gain and improved multiplexing slope (r=3/4) of CAO-SIR-FBC.

Multiplexing and SNR Gains

Traditional half-duplex relaying is limited to a multiplexing gain of $1/2$. CAO-SIR-FBC breaks this limit, achieving a gain of $3/4$ in a 3-relay setup. In i.i.d. scenarios, the proposed method achieved a 4.0 dB SNR gain over traditional relaying at a throughput of 4 bits/s/Hz.

Reliability and Efficiency

The protocol successfully maintains target error probabilities (e.g., $\epsilon_d = 10^{-3}$) by adapting rates to specific channel conditions. The steeper slope of the throughput curves in Figure 3 confirms that CAO-SIR-FBC utilizes the available spectrum much more efficiently than conventional protocols, particularly in high SNR regimes where performance is dominated by relay ordering.

Conclusion and Future Work

CAO-SIR-FBC represents a significant step forward for URLLC by successfully combining successive relaying with finite-blocklength constraints. While the protocol requires accurate Channel State Information (CSI), it offers substantial gains in spectral efficiency. Future research will explore dynamic relay selection and power allocation to further enhance performance in mobile environments.

Summary updated

BibTeX
@misc{zhang2022channel,
  author = {Lingrui Zhang and Yuxing Han and Qiong Wang and Wei Chen},
  title = {{Channel-Aware Ordered Successive Relaying with Finite-Blocklength Coding}},
  year = {2022},
  eprint = {2210.14627},
  archivePrefix = {arXiv},
  url = {https://arxiv.org/abs/2210.14627},
}
Figure