Abstract
Shapiro time delay is one of the fundamental tests of general relativity and post-Newtonian theories of gravity. Consequently, its measurements can be used to probe the parameter $\gamma$ which is related to spacetime curvature produced by a unit mass in the post-Newtonian formalism of gravity. To date all measurements of time delay have been conducted on astronomical scales. It was asserted in 2010 that gravitational wave detectors on Earth could be used to measure Shapiro delay on a terrestrial scale via massive rotating systems. Building on that work, we consider how measurements of Shapiro delay can be made using next-generation gravitational wave detectors. We perform an analysis for measuring Shapiro delay with the next-generation gravitational wave detectors Cosmic Explorer and Einstein Telescope to determine how precisely the effect can be measured. Using a rotating mass unit design, we find that Cosmic Explorer and Einstein Telescope can measure the Shapiro delay signal with amplitude signal to noise ratios upwards of ~28 and ~43 in 1 year of integration time, respectively. By measuring Shapiro delay with this technique, next-generation interferometers will allow for terrestrial measurements of $\gamma$ in the paramaterized post-Newtonian formalism of gravity with sub-percent precision.
Introduction
The Shapiro delay—the slowing of light as it passes through a gravitational potential—is a cornerstone test of General Relativity (GR). Traditionally, this effect is measured on astronomical scales, such as tracking the Cassini spacecraft as it passes near the Sun. While highly precise, these measurements rely on "found" experiments in space where initial conditions introduce inherent uncertainties. This research investigates the feasibility of bringing this test to Earth, allowing for a controlled, repeatable experiment using next-generation "third-generation" (3G) gravitational wave detectors.
Experimental Setup: The Rotating Mass Unit
The proposed experiment centers on a Rotating Mass Unit (RMU) placed near the laser arm of an interferometer. As a large bar with heavy masses at each end spins, it periodically modulates the local gravitational potential. This creates a time-varying Shapiro delay in the laser's travel time, which the detector can then measure.
The study modeled three RMU designs, ranging from an "Advanced" model (25,000 kg masses at 25 Hz) to a "Cost-conscious" model (6,500 kg masses at 15 Hz). Unlike astronomical measurements, the RMU's rotation can be precisely tuned to avoid noise lines in the detector's data stream.
Detector Sensitivity and Signal Analysis
The feasibility of this terrestrial measurement hinges on the vastly improved sensitivity of 3G detectors compared to current facilities like Advanced LIGO. The researchers utilized design sensitivity curves for the Cosmic Explorer (CE) and the Einstein Telescope (ET) to calculate expected Signal-to-Noise Ratios (SNR).
A key insight is the "Short Arm" advantage: the Einstein Telescope (10 km arms) actually performs better than the Cosmic Explorer (40 km arms) for this specific measurement. Because Shapiro delay is a local time-of-flight effect, the resulting strain signal ($h = c \delta t / L$) is inversely proportional to the arm length, making it larger in shorter detectors.
Key Results and Precision
The analysis demonstrates that 3G detectors can achieve significant SNRs within one year of integration time. Specifically, the "Advanced" RMU model yields an SNR of approximately 29 with CE and 43 with ET. These results suggest that the Parameterized Post-Newtonian (PPN) parameter $\gamma$—which equals 1 in General Relativity—could be measured with a standard error of 4.6% to 6.9% in one year. By employing an array of synchronized RMUs and integrating over 5–10 years, the precision could reach sub-percent levels (<1%).
Discussion and Limitations
While promising, the experiment faces significant engineering hurdles. Rotating 25-ton masses at high frequencies requires sophisticated carbon-fiber frames to manage the immense kinetic energy. Additionally, while the direct Newtonian gravitational pull on the detector's test masses is negligible for these 3G designs, it must still be carefully modeled. Despite these challenges, the ability to conduct a controlled, terrestrial verification of Shapiro delay represents a major leap forward for experimental gravity.
Summary updated