Abstract
The BER performance with consideration of phase fluctuation effect in space optical communication is investigated. When the phase fluctuation effect is considered, BER definitely increase which leads to the worse communication quality. Based on numerical simulation, BER is sensitive to the higher level of zenith angle. There exists the optimal point of divergence angle in practical system and this point turns to be lower if phase fluctuation effect is considered. After we analyze different BER performance in different wavelengths, we can know that 1550nm of wavelength is always the better choice for great communication quality. The work is beneficial for increasing the communication quality and designing the practical communication system.
Introduction
Space optical communication, or laser communication, offers significantly higher bandwidth than traditional radio frequency systems. However, its performance is severely limited by Earth's atmosphere. Atmospheric turbulence introduces three primary challenges: intensity scintillation (flickering), beam wander (physical displacement of the beam), and phase fluctuation (distortion of the light wave's phase). While intensity and wander are well-studied, phase fluctuation is increasingly critical for systems employing phase-shift keying (PSK) modulations like BPSK. This study quantifies the impact of phase noise on Bit Error Rate (BER) to guide the design of more resilient space-to-satellite optical uplinks.
Methodology
The researchers utilized a numerical simulation framework to model a Binary Phase Shift Keying (BPSK) uplink from a ground station (100m altitude) to a geostationary satellite (36,000km altitude). The model integrates intensity scintillation, beam wander (modeled via Rayleigh distributions), and phase fluctuation (modeled via Gaussian distributions) into a unified BER calculation. The Hufnagel-Valley model was used to characterize the atmospheric refractive index. Simulations compared three standard laser wavelengths—800nm, 1060nm, and 1550nm—across variables including transmission power (up to 2W), zenith angle, phase frequency, and beam divergence angle.
Results and Discussion
Numerical simulations reveal that phase noise is a primary driver of performance degradation. When phase fluctuation is included in the model, the BER increases substantially across all tested wavelengths.
As shown in the figure above, the 1550nm wavelength consistently outperforms 800nm and 1060nm, maintaining a lower BER even under high phase noise conditions. At 1W of transmission power, the inclusion of phase fluctuation increased the BER by approximately 48dB for 1550nm, 31dB for 1060nm, and 16dB for 800nm.
A critical finding involves the "optimal point" for beam divergence. In practical systems, there is a specific divergence angle that minimizes BER by balancing beam spread against tracking errors.
The simulations demonstrate that accounting for phase fluctuation shifts this optimal point toward narrower angles. For instance, the optimal divergence for 1550nm dropped from roughly 41μrad to 29μrad when phase noise was introduced. This suggests that hardware designs based solely on intensity models may result in sub-optimal, overly wide beams. Additionally, the system showed high sensitivity to the zenith angle; as the angle increases, the beam traverses more atmosphere, causing a rapid spike in BER.
Conclusion
This study highlights that atmospheric phase fluctuation is a fundamental limit on space optical communication quality. The 1550nm wavelength is identified as the most resilient choice for turbulent uplink scenarios. Furthermore, the shift in optimal divergence angle underscores the need for integrated modeling in system design. While these results are based on theoretical Hufnagel-Valley models, they provide a crucial foundation for future experimental validation and the development of adaptive optics or advanced modulation schemes to mitigate atmospheric phase noise.
Summary updated