Abstract
The quality classification of recycled aggregate is based on the water absorption rate and the density of the adhered mortar. However, the quality of recycled aggregate is affected by the adhesion characteristics between the original aggregate and mortar (Interfacial Transition Zone: ITZ). It has been reported that carbonation of recycled aggregate improves mortar quality, but the effect on the above adhesion interface is not clearly evaluated. In this study, laser-induced vibration method is conducted on recycled aggregate before and after carbonation to evaluate the quality of the adhesion interface between the aggregate and mortar. A simple spring model, in which the adhesion strength of the interface is expressed as a spring constant, is applied to the quality evaluation of the recycled aggregate. As a result, it is found that there is a correlation with Vickers hardness, which can measure the strength of the interface.
Introduction
As the construction industry transitions toward a circular economy, the use of recycled aggregate—crushed concrete repurposed as new stone—is becoming increasingly vital. A significant challenge in this transition is the presence of the Interfacial Transition Zone (ITZ), the boundary where old mortar remains adhered to the original stone. This zone is typically more porous and mechanically weaker than the bulk material, leading to increased water absorption and reduced durability.
While carbonation treatment (exposure to $CO_2$) is known to densify mortar and improve aggregate quality, evaluating these improvements remains difficult. Current standards rely on bulk measurements like water absorption, which do not directly assess bond strength. Traditional mechanical tests, such as Vickers hardness, are destructive and labor-intensive. This study explores a non-destructive alternative: the laser-induced vibration method.
Methodology
The research employs a combination of high-tech laser diagnostics and mechanical modeling to assess the ITZ.
Laser-Induced Vibration
A pulse laser is directed at the aggregate side of a sample, inducing surface ablation that triggers elastic waves throughout the material. A Laser Doppler Vibrometer (LDV) then measures the resulting vibration velocity on the adhered mortar side.
Modeling and Validation
The aggregate and mortar are modeled as two masses connected by a spring representing the ITZ. By measuring the peak vibration frequency, a "spring constant" ($k$) is calculated as a proxy for adhesion strength. To validate this method, samples were subjected to accelerated carbonation (5% $CO_2$ for one week). Validation was performed using Laser-Induced Breakdown Spectroscopy (LIBS) to map carbon content and Vickers hardness testing to provide a mechanical "ground truth."
Results and Discussion
The study utilized two concrete groups: Group A (W/C = 0.60, lower quality) and Group B (W/C = 0.45, higher quality).
Physical and Mechanical Improvements
Carbonation significantly improved the physical properties of the aggregates. Water absorption was reduced by 0.84% for Group A and 1.44% for Group B. Correspondingly, Vickers hardness in the ITZ increased by 10.4 HV and 17.6 HV, respectively. LIBS analysis confirmed that the ITZ often carbonates faster than the bulk mortar due to its higher initial porosity.
Vibration Analysis
The laser-induced vibration method successfully captured these quality shifts. The calculated spring constant ($k$) demonstrated a clear linear correlation with Vickers hardness. This suggests that the elastic behavior measured by the laser is a reliable indicator of mechanical bond strength. Furthermore, the shift in the relationship between the spring constant and hardness after carbonation implies a fundamental densification of the pore structure, rather than just a chemical change.
Conclusion
The laser-induced vibration method provides a promising non-destructive approach for evaluating the quality of recycled aggregates and the effectiveness of carbonation treatments. While future work is needed to account for complex 3D vibration modes in irregular shapes and to scale the setup for industrial use, the correlation with traditional hardness tests validates the underlying physical model.
Summary updated