Analytical Pyrolysis Study of Peanut Shells using TG-MS Technique and Characterization for the Waste Peanut Shell Ash

Xiwen Yao, Kaili Xu, Yu LiangJournal of Residuals Science and Technology 2016 · DOI

TL;DR

This study investigates the pyrolysis of peanut shells, a common agricultural waste, using thermogravimetric analysis coupled with mass spectrometry (TG-MS) under varying heating rates. The research not only characterizes the decomposition kinetics and gaseous emissions but also analyzes the resulting ash, revealing its potential for applications in glass production, concrete admixtures, and as a precursor for low-cost adsorbents.

What Problem Does This Paper Address?

Globally, agricultural waste presents a significant challenge for disposal and environmental management. Peanut shells, in particular, are produced in abundance and represent a potential resource if effectively utilized. While previous research has explored peanut shell pyrolysis, focusing primarily on kinetic modeling, there's a notable gap in understanding the evolution of gaseous products under different heating conditions and a comprehensive characterization of the resulting ash for potential applications. This paper aims to fill these gaps by providing a detailed analysis of peanut shell pyrolysis behavior, gas emissions, and the chemical and physical properties of the ash.

Methods

The researchers employed Thermogravimetric Analysis (TGA) coupled with Mass Spectrometry (MS) to study the pyrolysis of peanut shells. TGA was used to monitor weight loss as a function of temperature, while MS identified the evolved gases. Experiments were conducted under a helium atmosphere at various heating rates (5, 10, and 20 °C/min) up to 1200 °C.

For kinetic analysis, the Flynn-Wall-Ozawa (FWO) method, an iso-conversional technique, was utilized to determine the activation energy of the pyrolysis process. This method involves analyzing TGA data at different heating rates to extract kinetic parameters.

The resulting peanut shell ash (PSA) was characterized using several techniques:

  • X-ray Fluorescence (XRF) to determine the elemental composition.
  • X-ray Diffraction (XRD) to identify crystalline phases.
  • Scanning Electron Microscopy (SEM) coupled with Energy Dispersive X-ray Spectroscopy (EDX) to analyze the morphology, surface composition, and elemental distribution of the ash particles.

Datasets

Not discussed in the paper. The study utilized peanut shells collected from the countryside of Shenyang, China, as the primary material.

Key Insights and Ideas

  • Stepwise Decomposition: Peanut shell pyrolysis doesn't happen in one go; it proceeds in distinct stages, primarily influenced by the breakdown of hemicellulose, cellulose, and lignin.
  • Heating Rate Matters for Gas Production: Faster heating rates at lower temperatures appear more conducive to producing biogas, suggesting optimized conditions for energy generation.
  • Ash as a Valuable Resource: The generated ash isn't just waste; it's a rich source of silica and other metal oxides, making it a promising candidate for industrial applications.
  • Pore Formation for Adsorbents: The volatile matter released during pyrolysis creates pores in the carbonaceous residues, hinting at their potential for developing low-cost adsorbents.

Key Results

  • Kinetic Parameters: The decomposition of peanut shells follows a stepwise mechanism. The activation energy, calculated using the FWO method, ranged from 58.3 to 88.6 kJ·mol⁻¹, with an average of approximately 65.61 kJ/mol.
  • Gas Evolution:
    • CO emission was higher at a faster heating rate (20°C/min) and occurred throughout the process.
  • CO₂ and CH₄ emissions were primarily concentrated above 200°C, aligning with the biomass weight loss stages.
  • H₂ emission peaked between 300-500°C and was also higher at the faster heating rate.
  • Ash Composition: The peanut shell ash (PSA) was predominantly composed of SiO₂ (56.38%), followed by K₂O (10.40%), CaO (8.26%), and Al₂O₃ (8.73%). Other oxides were present in smaller amounts.
  • Ash Morphology: SEM images revealed that PSA particles are irregular in shape, ranging from 1 to 150 µm. Some unburned carbon residues were observed, and the presence of pores indicated potential for adsorbent applications.

Limitations and Future Work

  • Unburned Carbon: The presence of unburned carbon residues in the ash suggests that the combustion at 600°C might not have been complete, which could impact certain applications.
  • Amorphous Silica: While silica is abundant, it was found in an amorphous form, which might influence its reactivity or suitability for specific applications compared to crystalline silica.
  • Further Exploration Needed: The authors acknowledge that while the potential applications of PSA are identified (glass production, concrete admixtures, fertilizers, adsorbents), these applications have not yet been experimentally tested on the prepared PSA. Further research is needed to validate these potential uses and to provide a reliable estimation of PSA's industrial demand.
  • Mechanism of Activation Energy Change: The study noted that activation energy increases with conversion, implying a complex, multi-step reaction mechanism. Further investigation into the specific mechanisms driving this change is suggested for future work.

Summary updated

Abstract

As an agricultural waste produced from the processing of peanut, the yield of peanut shells in China is quite abundant. Although numerous studies on the pyrolysis of peanut shells have been carried out, most of them were focused on the dynamics models for predicting kinetics parameter of biomass, and rarely on the evolution of gaseous products in pyrolysis. This study carried out a set of experiments on the pyrolysis of peanut shells under different heating rates in order to fill the knowledge gap. Besides, there is also a lack of information available concerning the characterization of resulting peanut shell ash. Thus, the aim of this study is to investigate the pyrolysis behaviors of peanut shells thoroughly and to characterize the properties of peanut shell ash that serves as predictors for its applications. The results show that the decomposition of peanut shells follows a stepwise mechanism, and the activation energy calculated by Flynn- Wall-Ozawa method varies from 58.3 to 88.6 kJ·mol–1. Compared with low heating rate, fast heating rate at low temperatures is more suitable for biogas production. Chemical and phase analysis shows that peanut shell ash has a high SiO2 content except for other oxides (K2O, CaO, MgO, Al2O3, etc.) that quite suitable in glass production, implying its potential for glass production and as a mineral admixture in concrete. Released volatile matters in pyrolysis create many pores in carbonaceous materials, thus low-cost adsorbents can be produced from these carbon residues.
BibTeX
@article{yao2016analytical,
  author = {Xiwen Yao and Kaili Xu and Yu Liang},
  title = {{Analytical Pyrolysis Study of Peanut Shells using TG-MS Technique and Characterization for the Waste Peanut Shell Ash}},
  journal = {Journal of Residuals Science and Technology},
  year = {2016},
  doi = {10.12783/issn.1544-8053/13/4/7},
}
Figure