Introduction
As data centers and optical interconnects demand higher capacities, the industry is seeking ways to extend transmission distances while minimizing costs and power consumption. Intensity Modulation with Direct Detection (IM/DD) is the preferred approach for short-reach systems due to its simplicity. However, as distances stretch toward 40 km and beyond for inter-data center connections, signal attenuation becomes a major hurdle, traditionally requiring optical amplifiers. This study investigates the feasibility of achieving long-reach (60 km), high-speed (56 Gbit/s) transmission using low-cost, commercially available 25 Gbps components without the need for optical amplification.
Experimental Methodology
The researchers employed several key techniques to bridge the 60 km gap using standard single-mode fiber (SSMF). To achieve 56 Gbit/s from 25 Gbps-rated components, 4-level Pulse Amplitude Modulation (PAM4) was utilized, reducing the required electrical bandwidth to 28 Gbaud. The system operated in the O-band (1295.13 nm) to leverage naturally low fiber dispersion, minimizing signal distortion over long distances.
The core innovation was the implementation of a high-sensitivity receiver using an Avalanche Photodiode (APD) combined with a Trans-impedance Amplifier (TIA). Unlike standard PIN photodiodes (PD), APDs provide internal gain, which significantly improves receiver sensitivity. The experimental setup, shown above, allowed for a direct comparison between these two receiver types. At the receiver, offline Digital Signal Processing (DSP), including a 35-tap Decision-Directed Least Mean Square (DD-LMS) equalizer, was used to compensate for hardware limitations and clean up the signal.
Key Results and Discussion
The switch from a standard PIN photodiode to an APD proved to be the critical factor in extending the transmission reach. The APD-based system achieved a record distance of 60 km of SSMF without any optical amplification, successfully handling a total fiber loss of 20.7 dB.
As shown in the BER performance curves, the APD receiver provided a 7 dB improvement in sensitivity compared to the standard PD at the 7% Forward Error Correction (FEC) threshold (3.8e-3). This sensitivity gain directly translated to a 50% increase in transmission distance, extending the reach from 40 km to 60 km. The system reached receiver sensitivities of -20 dBm in back-to-back (BTB) configurations and -19.9 dBm after 60 km of transmission.
Conclusion
This research demonstrates that 25 Gbps-class commercial components, such as EMLs and APDs, can be pushed to support 56 Gbit/s PAM4 through effective DSP and modulation. By utilizing the O-band and high-sensitivity APD receivers, the need for complex and power-hungry optical amplifiers can be eliminated for reaches up to 60 km. This provides a highly cost-effective solution for next-generation client networks and inter-data center interconnects. Future work will focus on real-time DSP implementation and testing in Wavelength Division Multiplexing (WDM) environments to further increase total fiber capacity.
Summary updated