Abstract
Wireless grid can provide consumers ubiquitous broadband wireless services with convenience, robustness and mobility, which is one of the most promising alternatives of fixed wireless access networks. As the deployment of Wide City has accelerated quickly, this study focuses on the key technologies of wireless grid in ubiquitous broadband wireless services, such as antennas, MAC design, channel assignment and interface scheduling. A novel hierarchical wireless network based on WiMax-WiFi grid is proposed for mega-event. As a key enabling technology for wireless grid, a distributed power control algorithm for WiFi AP is proposed in this study to achieve the load balancing and the improvement of network performance.
Introduction
Providing seamless wireless coverage for "mega-events"—large-scale festivals or exhibitions—is a significant challenge for network engineers. These scenarios involve massive crowds, high mobility, and a critical need for high bandwidth across expansive areas, often referred to as "Wide City" deployments.
Current wireless mesh technologies often struggle with scalability. As more nodes are added to accommodate more users, networks frequently encounter the "hidden terminal" problem, increased signal interference, and MAC protocol inefficiencies. This research addresses the need for an architecture that combines long-range backhaul with local high-speed access while managing the interference of hundreds of overlapping signals.
Hierarchical WiMax-WiFi Grid Architecture
The authors propose a three-level hierarchical architecture to manage the complexity of mega-event networking:
- Normal Nodes (NN): Mobile end-user devices.
- Super Nodes (SN): WiFi Access Points (APs) that form the local mesh network.
- Hyper Nodes (HN) / WiMax BS: These provide the long-distance "backbone" (covering tens of kilometers) to connect local WiFi grids to the broader internet.
Integrating WiMax as a reliable, licensed-spectrum backhaul solves the "long-haul" bottleneck that plagues all-WiFi grids in metropolitan areas. Furthermore, the paper emphasizes Multi-Channel-Multi-Interface (MCMI) capabilities, allowing nodes to utilize multiple channels simultaneously to avoid throughput degradation.
Distributed Power Control Algorithm
A core contribution of this study is a distributed power control algorithm that allows WiFi APs to independently manage network load and interference without a centralized controller.
The Feedback Loop
Each AP monitors its performance by comparing actual throughput (based on received ACK packets) against the expected throughput of all connected clients. The expected signal strength is calculated using the Friis model for short-range propagation and the Two-Ray Ground Reflection model for longer distances.
Dynamic Adjustment
As shown in the flowchart, the algorithm uses transmission power as a proxy for load balancing:
- Congestion/Interference: If actual throughput drops significantly below expected levels, the AP reduces its transmission power. This "shrinks" the cell, effectively offloading users to neighboring, less-congested APs.
- Surplus Capacity: If there is a surplus of capacity, the AP increases power to expand its coverage area.
Simulation and Results
The approach was evaluated using NS2 (Network Simulator 2), modeling a scenario with 28 APs and 560 wireless clients (20 clients per AP). The simulation utilized 11Mbps bandwidth and a maximum transmission power of 0.2817W.
Key findings include:
- Convergence: The distributed algorithm converges quickly, with AP throughput stabilizing within approximately 30 iterations.
- Seamless Coverage: The 28 APs maintained seamless coverage across the simulated area with minimal mutual interference.
- Efficiency: The distributed nature of the algorithm reduces the computational overhead and communication lag typically associated with centralized "Control Center" management.
Limitations and Future Work
While promising, the study's results are based on NS2 simulations. Real-world mega-events involve complex physical obstructions and highly "bursty" traffic that may challenge the current fading models and the "light load" assumptions (10 Kbit/s per site) used in the simulation. Future research will focus on more sophisticated MAC protocols designed for MCMI environments and the cost-effectiveness of deploying advanced hardware like phased array antennas and MIMO in Super Nodes.
Summary updated