Abstract
This letter presents our design and experimental verification of a wideband dual-circular-polarized antenna operating in the W-band based on an optimized waveguide septum polarizer and a profiled smooth-wall horn. This antenna is capable of transmitting and receiving two orthogonal circular-polarized signals [left-hand circular polarization (LHCP) and right-hand circular polarization (RHCP)] simultaneously to achieve full-duplex, hence, twofold spectrum efficiency for millimeter-wave (mmWave) wireless communications. The fabricated antenna shows 21% relative bandwidth from 76.8 to 94.7 GHz with axial ratio < 5.8 dB; the reflection coefficient is below -15 dB and isolation > 20 dB for both LHCP and RHCP.
Introduction
As the demand for massive data rates drives wireless communications toward 6G and beyond, the millimeter-wave (mmWave) spectrum, particularly the W-band (75–110 GHz), has become a critical frontier. To maximize spectral efficiency, Polarization Division Multiplexing (PDM) is employed to double the data rate by transmitting two independent signals over the same frequency using orthogonal polarizations. While linear polarization is common, Circular Polarization (CP) offers superior robustness against polarization mismatch and multipath interference over long distances. However, designing dual-CP antennas at these high frequencies is challenging, often resulting in narrow bandwidths or poor port isolation. This work introduces a compact, wideband, and high-isolation dual-CP antenna designed specifically for W-band applications.
Antenna Design and Methodology
The proposed antenna architecture consists of three primary components optimized through electromagnetic simulations in CST Microwave Studio:
- Stepped Septum Polarizer: Acting as the core of the antenna, this component utilizes a four-step metal septum within a square waveguide. It converts incoming signals into two orthogonal components with a 90° phase shift, thereby generating circular polarization.
- Profiled Smooth-Wall Horn: To ensure a rotationally symmetric and stable radiation pattern across a wide bandwidth, a horn with a specific sinusoidal profile cascaded with a conical section was designed. This "profiled" approach offers a more compact form factor and easier manufacturability compared to traditional corrugated horns at W-band frequencies.
- Octagonal Waveguide Transformer: A multi-section octagonal transformer facilitates the transition from the square polarizer to the circular horn. This geometry is optimized for sub-millimeter scale fabrication while maintaining a reflection coefficient below -30 dB.
The design parameters were optimized using a hybrid approach combining Nelder-Mead Simplex and Particle Swarm Optimization (PSO) algorithms to achieve the desired performance metrics.
Fabrication and Experimental Results
The antenna was fabricated using a split-block milling process. The prototype's performance was verified using a THz Vector Network Analyzer (VNA) and an mmWave Compact Antenna Test Range (CATR).
Experimental measurements revealed a 21% relative bandwidth (76.8–94.7 GHz). The reflection coefficient ($S_{11}$) remained below -15 dB, and isolation between the LHCP and RHCP ports exceeded 20 dB across the entire band. The antenna achieved a stable gain of approximately 18.3 ± 2 dBic.
A key finding during the experimental phase was the extreme sensitivity to fabrication tolerances. A microscopic physical misalignment of just 23 $\mu$m between the two halves of the split-block assembly caused the measured Axial Ratio (AR) to degrade to < 5.8 dB, compared to the simulated < 2 dB. This highlights the critical importance of mechanical precision at W-band frequencies.
Conclusion
The developed dual-circular-polarized horn antenna demonstrates excellent wideband performance and high isolation, making it a strong candidate for full-duplex mmWave communications. While fabrication misalignments impacted the axial ratio, the overall results validate the design's potential. Future work will explore higher-precision fabrication techniques and the integration of this feed horn with high-gain reflector systems for long-distance backhaul links.
Summary updated