A novel auxiliary-free zero inductor current detection scheme for step down non-isolated LED driver

Jiajun Hu, Houpeng Chen, Xi Li, Qian Wang, Rong Jin, Yiyun Zhang, Zhitang SongIEICE Electron. Express 2014 · DOI

Abstract

To achieve high efficiency and power factor, non-isolated LED drivers often utilize Boundary Conduction Mode (BCM), which requires precise Zero Crossing Detection (ZCD) of the inductor current. Traditional ZCD methods rely on auxiliary windings that increase PCB footprint and cost. This paper introduces a novel auxiliary-free ZCD scheme that leverages the parasitic capacitance of the integrated LDMOS power switch to detect the zero-current state. The proposed design, fabricated in a 0.35 μm CMOS process, achieves a peak efficiency of 89.6% and maintains a high power factor across a wide input range (90V–285V AC).

Introduction

Modern LED lighting requires compact, efficient, and cost-effective driver circuits. Non-isolated step-down converters operating in Boundary Conduction Mode (BCM) are popular because they offer a good balance between efficiency and power factor. However, the standard implementation of BCM requires an auxiliary winding on the inductor to sense when the current reaches zero. These windings are physically bulky and complicate the manufacturing process. This research addresses the challenge of accurate ZCD without the need for additional hardware components.

Proposed ZCD Methodology

The proposed scheme utilizes the inherent parasitic drain-source capacitance ($C_{DS}$) of the LDMOS power switch as a signal bridge. When the inductor current reaches zero, a natural resonance occurs between the inductor and the parasitic capacitance. This resonance signal is coupled from the high-voltage drain to the low-voltage source of the LDMOS.

System architecture (a) and auxiliary-free ZCD sensing scheme (b)

By sensing the signal at the source terminal, the control logic is naturally isolated from high-voltage spikes (up to 600V) without requiring specialized high-voltage capacitors. The detection circuit employs a sample-and-hold technique: it captures the voltage at the end of the demagnetization period ($V_{Hold1}$) and uses a comparator to trigger the next switching cycle when the source voltage drops significantly below a threshold derived from the held value.

Experimental Results

The integrated chip was fabricated using a CZ6H 0.35 μm standard CMOS process. Performance evaluation across a wide input voltage range (90V to 285V AC) and varying load conditions (5 to 20 LEDs in series) yielded the following results:

  • Efficiency: A maximum power conversion efficiency of 89.6% was recorded at 220V AC input.
  • Power Factor: The system maintained a power factor (PF) greater than 0.88, meeting standard utility requirements.
  • Regulation: The design demonstrated robust stability with 3% line regulation and 3.2% load regulation.
  • Response Time: The ZCD trigger delay was approximately 200 ns, which is fast enough to maintain accurate BCM operation at switching frequencies up to 100 kHz.

Conclusion

The developed auxiliary-free ZCD scheme successfully eliminates the need for bulky secondary windings in BCM LED drivers. By repurposing parasitic capacitance as a functional sensing element and utilizing source-side detection for high-voltage isolation, the design achieves high integration and performance. Future work may explore the adaptation of this technique to other converter topologies and the integration of advanced dimming capabilities.

Summary updated

BibTeX
@article{hu2014novel,
  author = {Jiajun Hu and Houpeng Chen and Xi Li and Qian Wang and Rong Jin and Yiyun Zhang and Zhitang Song},
  title = {{A novel auxiliary-free zero inductor current detection scheme for step down non-isolated LED driver}},
  journal = {IEICE Electron. Express},
  year = {2014},
  doi = {10.1587/elex.11.20141011},
}
Figure