A Modified Four Path Method for Calculating Coupling Field of Super-Low Altitude Aircraft Target

Gao Xiang Zou, Chuangming Tong, Binglin Yu, Hua Long Sun, Tao SongJournal of Computer and Communications 2018 · DOI

Abstract

A novel modified four path method (FPM) is presented for calculating the coupling field of super-low altitude aircraft targets. Based on the hybrid method PO + MEC (Physical Optics and Method of Equivalent Currents), the antenna radiation pattern is introduced to consider multipath interference from the side lobes of the seeker. The modified FPM is used to calculate the coupling field from super-low altitude aircraft targets above different terrestrial environments. The curves of scattering coefficients are analyzed, and the influences of target height, root mean square (RMS) surface roughness, and incident angle on coupling field characteristics are discussed. The simulation results provide a reference for detecting super-low altitude targets and optimizing radar systems.

Introduction: The Challenge of Super-Low Altitude Detection

Detecting aircraft flying at super-low altitudes is a notorious challenge for radar systems. When a target is close to the earth's surface, the radar receiver doesn't just see the direct reflection from the aircraft; it also sees "multipath" signals that have bounced off the ground. This collection of extra signals is known as the coupling field.

Traditional models, like the standard Four Path Method (FPM), treat the radar seeker as a point that receives all signals equally. In reality, radar antennas have a specific radiation pattern: they are highly sensitive in the direction they are pointing (the main lobe) but also pick up weaker signals from the sides (side lobes). Ignoring these side lobes leads to inaccurate predictions of interference, making it harder to optimize radar systems for low-altitude defense.

Methodology: The Modified Four Path Method

The authors propose a Modified Four Path Method that bridges the gap between theoretical electromagnetics and practical antenna design. Their approach combines several key elements to simulate the complex interaction between the radar, the target, and the ground.

Geometry of the Four Path Method (FPM) for low-altitude target detection.

Hybrid Scattering Calculation

To model the aircraft itself, the researchers use a hybrid approach. Physical Optics (PO) is employed to calculate how waves bounce off the flat facets of the aircraft, while the Method of Equivalent Currents (MEC) handles the tricky diffraction that occurs at the aircraft's sharp edges. The target model is subdivided into numerous triangle facets using Hypermesh software to ensure high fidelity.

Antenna Radiation Pattern and Correction Factor

Instead of assuming a uniform receiver, the study introduces a mathematical model (a Gauss function) that defines a main lobe and two distinct side lobes. The "secret sauce" of this research is the Correction Factor (ξ). This factor weights incoming multipath signals based on whether they enter the seeker through the high-gain main lobe or the lower-gain side lobes, providing a much more granular look at radar performance than the traditional FPM.

Environment Modeling

The study accounts for different ground types—concrete, dry land, and wet land—using a modified complex reflection coefficient. It also considers surface roughness (RMS height) to see how terrain texture affects signal propagation.

Key Insights and Results

The Brewster Angle Advantage

The study confirms that the coupling effect (interference) is weakest when the radar's grazing angle matches the Brewster angle of the ground surface. At this specific angle, the ground absorbs or transmits more of the vertically polarized wave, leaving less energy to bounce back and interfere with the target signal.

Simulation results for concrete terrain showing the scattering coefficient minimum at the Brewster angle (30°).

The model successfully identified the minimum interference angles for different surfaces: 30° for concrete, 26.5° for dry land, and 10° for wet land.

Terrain and Orientation Effects

  • The "Tail-On" Problem: Simulations showed a massive peak in multipath interference when the seeker detects the aircraft from the rear (an azimuth of 180°). This suggests that tail-on tracking is the most interference-prone orientation for low-altitude targets.
  • Roughness as a Dampener: Counter-intuitively, as the ground gets rougher (higher RMS), the coupling field actually decreases. This is because a rougher surface causes "diffuse scattering"—the energy is scattered in many random directions rather than being focused into a strong multipath bounce toward the radar.
  • Height Sensitivity: As the aircraft climbs (from 15m to 90m), the coupling field weakens, and the "optimal" angle for detection (the minimum interference point) shifts slightly lower.

Conclusion and Future Work

While the modified FPM provides a significant step forward in modeling low-altitude radar interference, several areas remain for future exploration. The current results focus on VV (Vertical-to-Vertical) polarization, where the Brewster effect is most prominent; however, real-world systems using horizontal or circular polarization may behave differently. Additionally, while the mathematical model is rigorous, future iterations could incorporate atmospheric effects like ducting or weather-related attenuation, and eventually undergo validation through real-world flight tests.

Summary updated

Abstract

A novel modified four path method (FPM) is presented for calculating coupling field of super-low altitude aircraft target. Based on the hybrid method PO + MEC (Physical Optics and Method of Equivalent Currents), the antenna radiation pattern is introduced to consider the multipath interference from side lobe of seeker. The modified FPM is used to calculate the coupling field from super-low altitude aircraft target above different terrestrial environments. The curves of scattering coefficient are analyzed. The influences of height of target, root mean square (RMS), and incident angle on coupling field characteristics are discussed. The simulation results can be used for reference in detection for super-low altitude target and optimization for radar system.
BibTeX
@article{zou2018modified,
  author = {Gao Xiang Zou and Chuangming Tong and Binglin Yu and Hua Long Sun and Tao Song},
  title = {{A Modified Four Path Method for Calculating Coupling Field of Super-Low Altitude Aircraft Target}},
  journal = {Journal of Computer and Communications},
  year = {2018},
  doi = {10.4236/jcc.2018.612006},
}
Figure