Abstract
This paper proposes a method for designing microstrip filters composed of open and shorted stubs based on the Theory of Small Reflections. By employing gradient optimization to determine stub dimensions, the authors developed broadband (5–8 GHz) and dual-band (2.4/5.8 GHz) filters. Experimental results show a high degree of correlation between calculated and measured reflection coefficients, validating the method's effectiveness for creating compact, easily fabricated filters with arbitrary passbands.
Introduction
Designing filters with arbitrary passbands—such as extremely wide bands or multiple discrete bands—remains a significant challenge in RF and microwave engineering. Traditional stepped-impedance filters, while effective for low-pass applications, often fall short in broadband performance and can require complex, inhomogeneous substrates. This research addresses these limitations by extending the Theory of Small Reflections to design high-performance filters using standard microstrip stubs on uniform substrates.
Design Methodology
The proposed design method leverages the characteristic admittance of transmission line sections loaded with parallel open and shorted stubs. This approach treats filter design as a generalized impedance matching problem where the "match" (zero reflection) is required only within specific frequency windows.
- Theoretical Extension: The standard Theory of Small Reflections is modified by loading transmission line sections with stubs. This adds an imaginary component to the admittance, allowing local reflection coefficients to function as complex frequency response variables.
- Optimization: A gradient descent algorithm is used to minimize the error between target "ideal" S-parameters and calculated values. The algorithm iteratively updates the physical lengths ($L_n$) of the stubs until convergence is achieved.
- Transmission Zero Control: A key insight of this work is the ability to control transmission zeros (TZs) by adjusting specific stub lengths, enabling sharper roll-off at passband edges without disrupting in-band performance.
Experimental Results
Two prototype filters were fabricated on Rogers RO4350 substrates to verify the design approach. The comparison between calculated and measured data demonstrates the accuracy of the proposed model.
- Broadband Filter (Filter 1): Targeted for a 5–8 GHz passband, the measured 3dB passband was 4.5–8.3 GHz. The measured results closely matched the calculated reflection curves, proving the method's reliability for wideband applications.
- Dual-band Filter (Filter 2): Designed for the 2.4 GHz and 5.8 GHz WLAN bands, it achieved measured passbands of 2.2–2.6 GHz and 5.5–5.9 GHz.
- Miniaturization: The dual-band filter demonstrated significant size reduction, with a physical length of 4.5 mm—approximately 65% smaller than a comparable fifth-order Chebyshev filter (13 mm).
Conclusion
The method based on the Theory of Small Reflections provides a robust framework for designing arbitrary passband microstrip filters. By using only open and shorted stubs, the resulting designs are not only high-performing but also easier to manufacture and significantly more compact than traditional alternatives. Future work may involve integrating this optimization directly into standard CAD tools for microwave engineering.
Summary updated