A DAFT Based Unified Waveform Design Framework for High-Mobility Communications

Xingyao Zhang, Haoran Yin, Yanqun Tang, Yu Zhou, Yuqing Liu, Jinming Du, Yipeng DingarXiv 2024 · DOI · arXiv

Abstract

With the increasing demand for multi-carrier communication in high-mobility scenarios, it is urgent to design new multi-carrier communication waveforms that can resist large delay-Doppler spreads. Various multi-carrier waveforms in the transform domain were proposed for the fast time-varying channels, including orthogonal time frequency space (OTFS), orthogonal chirp division multiplexing (OCDM), and affine frequency division multiplexing (AFDM). Among these, the AFDM is a strong candidate for its low implementation complexity and ability to achieve optimal diversity. This paper unifies the waveforms based on the discrete affine Fourier transform (DAFT) by using the chirp slope factor "k" in the time-frequency representation to construct a unified design framework for high-mobility communications. The design framework is employed to verify that the bit error rate performance of the DAFT-based waveform can be enhanced when the signal-to-noise ratio (SNR) is sufficiently high by adjusting the chirp slope factor "k".

Introduction

In the era of 5G and the upcoming 6G, high-mobility communication is a critical challenge. Receivers in high-speed environments, such as high-speed railways or UAV networks, experience significant Doppler shifts that cause signal distortion. Traditional Orthogonal Frequency Division Multiplexing (OFDM), while effective in static or low-speed scenarios, suffers from inter-carrier interference (ICI) when subcarriers are "smudged" by these shifts.

While specialized waveforms like Orthogonal Time Frequency Space (OTFS) and Affine Frequency Division Multiplexing (AFDM) have been developed to address these issues, they are often treated as distinct entities. This research introduces a unified mathematical framework based on the Discrete Affine Fourier Transform (DAFT), revealing that popular waveforms like OFDM, OCDM, and AFDM are specific instances of a single underlying architecture differentiated primarily by a "chirp slope" factor.

The Unified Framework

The proposed framework views any multi-carrier waveform as a specific distribution of subcarriers on the time-frequency plane. By leveraging the DAFT, the system can adapt its transform domain to match the characteristics of the communication channel.

Schematic diagram of the proposed unified waveform design framework.

As shown in the schematic above, the framework integrates mapping, waveform selection, parameter optimization, and detection into a cohesive pipeline. The core of the transmitter and receiver is the DAFT/IDAFT block, which can be configured to represent different waveforms by selecting specific parameters, most notably the chirp slope $k$.

The Role of the Chirp Slope ($k$)

The researchers identify the chirp slope factor $k$ as the fundamental parameter that defines the waveform's geometric representation in the time-frequency domain. By varying $k$, the framework can generate different waveforms:

  • $k = 0$: Subcarriers are horizontal lines, resulting in standard OFDM.
  • $k = 1$: Subcarriers are tilted at a 45-degree angle, resulting in OCDM.
  • $k = 2Nc_1$: Subcarriers have a flexible tilt, resulting in AFDM.
Time-frequency representations of subcarriers for different chirp slope values k.

This geometric unification demonstrates that OFDM, OCDM, and AFDM are essentially different "rotations" of information. AFDM, with its additional adjustable parameters ($c_1, c_2$), acts as a flexible "super-set" that can be optimized to prevent path interference in doubly dispersive channels, thereby achieving full diversity gain.

Key Results and Insights

The study utilized numerical simulations of doubly dispersive channels (using the Jakes Doppler Spectrum) at speeds up to 540 km/h. Key findings include:

  • Superior Performance: AFDM consistently achieved a lower Bit Error Rate (BER) compared to OFDM and OCDM, particularly in high-SNR regimes where parameter optimization is most effective.
  • Mobility Resilience: While OFDM performance degrades significantly as speed increases, DAFT-based waveforms (AFDM, OCDM) and OTFS remain remarkably stable, showing high immunity to Doppler shifts.
  • Detector Synergy: The choice of receiver is crucial. The authors found that a Message Passing (MP) detector significantly outperforms the standard Linear Minimum Mean Square Error (LMMSE) detector for these chirp-based waveforms.

Conclusion and Future Work

This unified framework provides a powerful tool for designing waveforms tailored to extreme mobility. By tuning the chirp slope $k$, engineers can optimize communication for specific Doppler environments. Future research will focus on reducing the computational overhead of searching for optimal parameters and integrating practical channel estimation techniques to move this framework from simulation to real-world hardware implementation.

Summary updated

Abstract

With the increasing demand for multi-carrier communication in high-mobility scenarios, it is urgent to design new multi-carrier communication waveforms that can resist large delay-Doppler spreads. Various multi-carrier waveforms in the transform domain were proposed for the fast time-varying channels, including orthogonal time frequency space (OTFS), orthogonal chirp division multiplexing (OCDM), and affine frequency division multiplexing (AFDM). Among these, the AFDM is a strong candidate for its low implementation complexity and ability to achieve optimal diversity. This paper unifies the waveforms based on the discrete affine Fourier transform (DAFT) by using the chirp slope factor "k" in the time-frequency representation to construct a unified design framework for high-mobility communications. The design framework is employed to verify that the bit error rate performance of the DAFT-based waveform can be enhanced when the signal-to-noise ratio (SNR) is sufficiently high by adjusting the chirp slope factor "k".
BibTeX
@misc{zhang2024daft,
  author = {Xingyao Zhang and Haoran Yin and Yanqun Tang and Yu Zhou and Yuqing Liu and Jinming Du and Yipeng Ding},
  title = {{A DAFT Based Unified Waveform Design Framework for High-Mobility Communications}},
  year = {2024},
  eprint = {2406.02262},
  archivePrefix = {arXiv},
  url = {https://arxiv.org/abs/2406.02262},
}
Figure