Abstract
This paper presents a broadband out-of-phase power divider designed for high power-handling capability. The device utilizes double-sided parallel-strip lines (DSPSLs) with a mid-inserted conductor plane and external isolation resistors directly grounded for efficient heat sinking. A key innovation is the Through Ground Via (TGV), which shorts isolation resistors during odd-mode excitation across the full frequency band while remaining "invisible" during even-mode excitation. This property significantly improves bandwidth. Analytical modeling and experimental verification of a 1.25/1.75 GHz prototype demonstrate a 44.3% bandwidth with >15 dB return loss and >18 dB isolation, making it ideal for high-power RF applications.
Introduction
In modern RF engineering, out-of-phase (180°) power dividers are essential for balanced circuits such as push-pull amplifiers and antennas. However, conventional designs often struggle with two major issues: heat dissipation and limited bandwidth. Standard Wilkinson dividers typically use internal resistors that are difficult to cool, and previous wideband designs using Double-Sided Parallel-Strip Lines (DSPSLs) often suffered from narrow operating ranges. This research introduces a novel architecture that addresses these challenges by using a Through Ground Via (TGV) to enable external grounding of isolation resistors and broader frequency response.
Design and Methodology
The proposed power divider is built on a DSPSL structure featuring a central ground plane. The core innovation is the TGV, a metal via connecting the top and bottom strips through this ground plane.
The TGV exhibits mode-selective behavior as shown in Figure 1:
- Odd-mode (out-of-phase): The TGV acts as a frequency-independent short circuit for the isolation resistors. This is a critical departure from standard designs that rely on frequency-sensitive quarter-wavelength lines.
- Even-mode (in-phase): The TGV is effectively transparent, allowing the signal to pass without interference.
This frequency-independent shorting allows for a much wider bandwidth than traditional methods. The authors derived closed-form ABCD matrix equations to optimize the impedance matching networks for dual-band operation.
Physical Implementation
The physical layout consists of multiple sections of DSPSLs with varying widths and lengths to achieve the required impedance matching.
By placing the isolation resistors externally and grounding them directly to the chassis or heat sink, the design ensures superior thermal management compared to internal resistor configurations. This makes the divider particularly suitable for high-power industrial and communication systems.
Results and Discussion
A prototype operating at 1.25 GHz and 1.75 GHz was fabricated on a Rogers 4350 substrate. Experimental measurements closely matched the theoretical models:
- Bandwidth: A fractional bandwidth of 44.3% (630 MHz) was achieved.
- Return Loss and Isolation: Return loss was maintained better than 15 dB, while port isolation exceeded 18 dB across the band.
- Phase Accuracy: The output signals maintained a phase difference of 180° ± 6°.
While the insertion loss of 3.7 dB was slightly higher than ideal, it was largely attributed to connector and dielectric losses, which could be mitigated with higher-grade materials.
Conclusion
The integration of a Through Ground Via into a DSPSL power divider provides a robust solution for high-power, wideband out-of-phase signal splitting. By enabling external grounding of isolation resistors and providing frequency-independent mode selection, this design overcomes traditional thermal and bandwidth constraints. Future work will focus on miniaturization and extending the design to even higher frequency ratios.
Summary updated