3D alginate hydrogel microspheres with uniform micro-structure for cell culture and CVB3 infection

Tianyi Zhang, Yuqing Xu, Y. Z. Sun, Kun Ye, Jiarong Liu, Rui Zhang, Sirong Yu, Z. Jane Wang, Min Li, Hua Wang, Hongxing Shen, Xiaoxiang ZhouResearch Square 2025 · DOI

Introduction

Traditional virological research has long relied on two-dimensional (2D) cell culture models. While these models are cost-effective and easy to manage, they fail to replicate the complex three-dimensional (3D) architecture, mechanical cues, and nutrient gradients found within living organisms. Conversely, animal models, while physiologically relevant, are often prohibitively expensive and present significant ethical challenges. To bridge this gap, researchers from Jiangsu University have developed a robust 3D cell culture model using an integrated microfluidic platform to encapsulate HeLa cells within uniform alginate hydrogel microspheres (AHMs).

The Microfluidic Platform and Microsphere Generation

The core of this research lies in a droplet-based microfluidic approach designed to overcome the limitations of traditional alginate gelation. Standard methods often result in non-uniform, "tadpole-shaped" particles. To achieve high monodispersity, the team employed a one-step internal gelation method using a ligand-exchange crosslinking process. By mixing alginate with chelated calcium (Ca-EDTA) and zinc (Zn-EDDA), the researchers triggered uniform gelation from the inside out as the phases interacted within the microfluidic chip.

Schematic of the microfluidic platform for generating uniform alginate hydrogel microspheres (AHMs).

This platform allows for precise control over the size of the microspheres. By adjusting the flow rate ratio of the oil phase to the alginate phase, the team could predictably tune the diameter of the AHMs. The resulting microspheres exhibited remarkable uniformity, with a coefficient of variation (CV) of less than 5%, ensuring experimental consistency across samples.

Optimizing the 3D Matrix for Viral Accessibility

A critical challenge in 3D infection modeling is balancing structural integrity with the permeability required for viral entry. The researchers investigated the impact of alginate concentration on the infection rates of Coxsackievirus B3 (CVB3-eGFP).

They discovered a "Goldilocks" density at a concentration of 0.6%. At higher concentrations (1.0%), the dense hydrogel matrix acted as a physical barrier, shielding the encapsulated cells from the virus. Conversely, concentrations below 0.4% resulted in fragile microspheres that could not maintain their 3D structure. The 0.6% concentration provided the optimal balance, maintaining a stable 3D environment while remaining porous enough to allow for efficient viral infection.

Results: Cell Viability and Infection Kinetics

The encapsulation process proved to be exceptionally gentle. Quantitative analysis using Calcein AM/PI staining revealed that HeLa cells maintained a high viability rate of 95–97% over a three-day culture period. Within the AHMs, cells transitioned from individual encapsulated units into natural clusters and spheres, more closely mimicking the high-density growth patterns seen in solid tissues compared to the flat, thin morphology of 2D cultures.

Successful viral infection within the 3D matrix was confirmed using a modified CVB3 expressing enhanced green fluorescent protein (eGFP). Fluorescence imaging and Western blot analysis of the viral protein VP1 demonstrated that infection kinetics were directly influenced by the matrix density. As the alginate concentration was tuned down to the 0.6% sweet spot, viral protein expression significantly increased, validating the model's utility for studying virus-host interactions.

Conclusion and Future Directions

This study establishes a tunable and reproducible 3D model that offers a physiologically relevant alternative to 2D cultures and animal models. By optimizing the physical properties of the alginate scaffold, the researchers have created a "micro-reactor" environment suitable for high-throughput virology research.

Future work may involve incorporating extracellular matrix (ECM) proteins like collagen to better simulate specific organ environments, such as cardiac tissue. Additionally, integrating this platform with multi-omics analysis or moving toward co-culture models (e.g., combining epithelial cells with immune cells) could further enhance its power for antiviral drug screening and infectious disease modeling.

Summary updated

Abstract

<title>Abstract</title> Viral organisms characterized by elevated transmissibility and pathogenicity constitute a substantial public health risk. Three-dimensional (3D) cell culture systems better mimic the <italic>in vivo</italic> microenvironment than traditional two-dimensional (2D) models, offering significant potential for virological research. Therefore, a method for natural viral growth based on 3D cell culture need be developed. In this study, we developed an integrated microfluidic platform for the efficient generation of highly uniform alginate hydrogel microspheres (AHMs) encapsulating HeLa cells, enabling robust 3D cell culture and subsequent infection with Coxsackievirus B3 expressing enhanced green fluorescent protein (CVB3-eGFP). Our results demonstrate that AHMs support high cell viability and facilitated cell proliferation within a biomimetic 3D matrix. By systematically reducing the alginate concentration from 1.0% to 0.6%, we enhanced viral accessibility while maintaining microstructural integrity, thereby significantly improving CVB3-eGFP infection rates, as confirmed by fluorescence imaging and western blot analysis. This study establishes a tunable, reproducible, and physiologically relevant 3D model for studying virus–host interactions, with broad applications in antiviral drug screening and infectious disease modeling.
BibTeX
@inproceedings{zhang2025d,
  author = {Tianyi Zhang and Yuqing Xu and Y. Z. Sun and Kun Ye and Jiarong Liu and Rui Zhang and Sirong Yu and Z. Jane Wang and Min Li and Hua Wang and Hongxing Shen and Xiaoxiang Zhou},
  title = {{3D alginate hydrogel microspheres with uniform micro-structure for cell culture and CVB3 infection}},
  booktitle = {Research Square},
  year = {2025},
  doi = {10.21203/rs.3.rs-7659713/v1},
}
Figure