Abstract
Sunlight is everywhere around the world, and solar cells can be used; the working principle of solar cells is to directly convert solar energy into electricity, which does not need a secondary conversion process, so it has a high conversion efficiency. How to make full use of solar energy for power generation has become a key topic of development research in various countries. In this paper, we design and develop a high-efficiency solar energy receiving system based on maximum power tracking with the STM32H750VB microcontroller as the core controller. We collect the system current and voltage state parameters through the sampling module and use the variable step conductance incremental method combined with the PID control algorithm to control the input lifting and lowering module. This controls the output power of the solar panel to achieve the goal of tracking the maximum power point at any time. As can be seen from the experimental results, the system can quickly achieve the goal of tracking the maximum power point and has high practical value.
Introduction
Solar energy conversion efficiency is a critical factor in sustainable power generation. Unlike many energy sources, solar cells convert light directly into electricity. However, their output is non-linear and highly dependent on environmental conditions such as irradiance and temperature. To maximize energy extraction, systems employ Maximum Power Point Tracking (MPPT).
The standard conductance increment method is widely used for MPPT but suffers from a fundamental trade-off: large steps provide speed but cause steady-state oscillations, while small steps offer precision but slow response times. This paper addresses this conflict by introducing a variable step conductance incremental method implemented on an STM32H750VB microcontroller.
Methodology
Hardware Architecture
The researchers developed a hardware-software co-design centered around the STM32H750VB microcontroller. The system consists of a simulation module (using a regulated power supply and internal resistance to mimic PV cells), a boost module, and a "booster and lowering" (buck-boost) module to manage the load and battery charging. Dual sampling modules monitor voltage and current in real-time to provide feedback for the control loop.
The Variable Step Algorithm
The core innovation is the division of the PV power characteristic curve into six segments (labeled A through F). This allows the system to apply different tracking logic depending on the proximity to the maximum power point (P).
In zones far from the peak (A-B and E-F), the algorithm uses a fixed large step for rapid convergence. As the system enters the "fine tracking" zones (B-E) near the peak, the step size becomes proportional to the slope of the curve. As the slope decreases, the step size is reduced, minimizing oscillations and ensuring high steady-state accuracy.
Key Results
The system's performance was validated by comparing measured output voltages ($U_1$) against theoretical maximums. In this specific simulation setup, the maximum power point is theoretically reached when $U_0 = 2U_1$. The experimental data showed an error rate consistently below 1%. For example, with a simulated input of $U_0 = 100V$, the system tracked a maximum power voltage of 49.996V, nearly identical to the theoretical target of 50.005V. The system demonstrated both rapid responsiveness to simulated light fluctuations and high steady-state stability without the typical "shocks" seen in fixed-step systems.
Conclusion and Future Work
This research demonstrates a robust MPPT system that balances tracking speed and precision through a zone-based variable step approach. Future work will focus on transitioning from simulated environments to real-world solar panel testing under diverse weather conditions, as well as further optimizing the algorithm for lower computational overhead and reduced hardware costs.
Summary updated