Abstract
To achieve near-continuous vertical observations of volatile organic compounds (VOCs) in the planetary boundary layer (PBL), multi-channel whole-air sampling equipment onboard an unmanned aerial vehicle (UAV) platform was developed in this study. The equipment consists of a multi-position solenoid valve and specially designed lightweight quartz sampling canisters. The canisters have little adsorption loss of VOCs and good inter-canister reproducibility. The 7-day recovery test shows that most VOC species (97 %) had a one-week decay within 20 %. Online instruments for measuring $O_3$, $NO_2$, $CO$, $SO_2$, and meteorological parameters are also integrated into the UAV platform. During one take-off and landing, the UAV platform can reach 800 m above the ground within 40 min and take whole-air samples at six heights. Vertical profiles of VOCs and trace gases during the evolution of the PBL in southwest China are successfully obtained by deploying the newly developed UAV system.
Introduction
Volatile organic compounds (VOCs) are critical drivers of air pollution and atmospheric oxidation, yet their vertical distribution within the planetary boundary layer (PBL) remains poorly understood. Traditional observation methods face significant limitations: ground-based towers are restricted in height, aircraft are often too fast and expensive for fine-scale low-altitude mapping, and tethered balloons lack maneuverability. Previous UAV-based efforts were often constrained by weight, typically carrying only a single heavy stainless-steel canister per flight, which made gradient measurements time-consuming and inefficient.
The UAV System
To overcome these limitations, researchers developed an integrated sampling payload for an AX-50J hexacopter. The system features several core innovations designed to maximize data collection while minimizing weight and contamination.
As shown in the figure above, the core of the system is a set of lightweight 1.1-liter quartz canisters, each weighing approximately 415g. These canisters replace traditional, heavier SUMMA canisters. Their inner surfaces are polished to minimize adsorption loss, ensuring sample integrity. A 16-position solenoid valve allows the UAV to switch between 6 to 8 canisters mid-flight via remote control. In addition to VOC sampling, the platform integrates online sensors for ozone ($O_3$), nitrogen dioxide ($NO_2$), carbon monoxide ($CO$), sulfur dioxide ($SO_2$), and meteorological parameters.
A key operational strategy is the "descent" sampling pattern. The UAV first ascends to its maximum altitude (800m) and then collects samples during its descent. This approach minimizes "dead volume" contamination because the drone moves from cleaner air at higher altitudes into more polluted air near the surface, making any residual air in the sampling lines negligible for the subsequent sample.
Performance and Field Results
Validation tests confirmed that the specially treated quartz canisters are a viable alternative to industry-standard stainless steel. They achieved an inter-canister reproducibility (CV) of 6.9%, slightly outperforming the 7.2% typically seen in SUMMA canisters. A 7-day recovery test demonstrated that 97% of the 97 measured VOC species experienced less than 20% decay, confirming their suitability for offline laboratory analysis.
Field campaigns in Chengdu, China, successfully captured 26 vertical profiles (182 VOC samples) between December 2021 and January 2022. These observations revealed significant chemical stratification within the PBL. For instance, morning temperature inversions were found to trap reactive species like alkenes and aromatics near the ground. In contrast, oxygenated VOCs (OVOCs) often increased with altitude, suggesting secondary chemical formation in the upper layers of the boundary layer.
Conclusion
The newly developed UAV system provides a highly efficient "flying laboratory" for atmospheric chemistry, capable of reaching 800m and collecting six distinct samples within a single 40-minute flight. While current battery technology limits flight times to approximately 43 minutes, and some electrochemical sensors face sensitivity challenges at high altitudes, the system represents a major step forward in high-resolution vertical VOC profiling. Future work will focus on improving UAV endurance and integrating more sensitive sensors to further enhance the platform's capabilities.
Summary updated