Author Correction: Portable and Error-Free DNA-Based Data Storage

S. M. Hossein Tabatabaei Yazdi, Ryan Gabrys, Olgica MilenkovićScientific 2020 · DOI · OpenAlex

Abstract

This correction addresses mathematical errors in the supplementary information of the 2017 study "Portable and Error-Free DNA-Based Data Storage." The adjustments revise the reported DNA storage density from $1.1 \times 10^{23}$ bytes/gram to $4 \times 10^{20}$ bytes/gram. While the density claim is reduced, the reported information rate of 0.85 remains accurate and continues to represent a significant benchmark in the field.

Introduction

The original research published in 2017 proposed a system for portable and error-free DNA-based data storage, highlighting high storage density as a key performance metric. Storage density, defined as the amount of data stored per unit mass of DNA, is a critical benchmark for comparing biological storage to traditional silicon-based technologies. Following publication, typographical errors were discovered in the supplementary calculations that led to an overestimation of this density. This correction serves to align the published record with the physical realities of the experimental results.

Mathematical Correction

The errors were localized to "Expression (9)" in the Supplementary Information. The correction involves two primary adjustments to the calculation of storage density:

  1. Nucleotide Mass Constant: The denominator of the density calculation was updated to include the term $650/2$, which accounts for the average mass of a nucleotide in daltons. This physical constant is essential for converting molecular counts into mass.
  2. Multiplier Placement: A multiplier of 0.85 was erroneously included in the numerator of the original expression. Removing this misplaced multiplier and correcting the mass constant resulted in a shift of the calculated density by approximately three orders of magnitude.

Revised Results

The primary impact of these corrections is the recalibration of the system's density metrics. The following table summarizes the changes:

Metric Original Value Corrected Value
Storage Density $1.1 \times 10^{23}$ bytes/gram $4 \times 10^{20}$ bytes/gram
Information Rate 0.85 0.85

As a result of these changes, the authors have revised the Abstract of the original paper to remove the claim of achieving the "highest reported... density." However, the "information rate" of 0.85 remains a significant achievement and is still cited as a leading figure in DNA data storage research.

Conclusion

The correction ensures that the physical limits and performance of the DNA storage system are accurately represented. Even at the corrected density of $4 \times 10^{20}$ bytes/gram, DNA remains a highly competitive medium compared to traditional hard drives or flash memory, which typically operate many orders of magnitude below the theoretical limits of biological storage. The original article and its supplemental materials have been updated to prevent the propagation of the incorrect figures.

Summary updated

Abstract

An amendment to this paper has been published and can be accessed via a link at the top of the paper.
BibTeX
@inproceedings{yazdi2020author,
  author = {S. M. Hossein Tabatabaei Yazdi and Ryan Gabrys and Olgica Milenković},
  title = {{Author Correction: Portable and Error-Free DNA-Based Data Storage}},
  booktitle = {Scientific},
  year = {2020},
  doi = {10.1038/s41598-020-60080-9},
}

Loading related content...

Figure