Antenna Array Design in Aperture Synthesis Radiometers

Jian Dong, Qing LiInTech 2010 · DOI · OpenAlex

Abstract

Antenna array design is a critical factor for aperture synthesis radiometers (ASR). This paper addresses two primary subjects: the optimization of antenna array configurations to determine spatial sampling performance, and the practical design of an antenna array for a millimeter-wave ASR system. Topology optimization aims to identify Minimum Redundancy Arrays (MRAs) that provide uniform and complete (u, v) coverage in the Fourier plane with minimal antenna elements, thereby maximizing spatial resolution. We present a restricted search method for large linear arrays and combinatorial methods for thinned circular arrays. Additionally, we detail a sparse antenna array with a parabolic cylinder reflector for the HUST-ASR prototype. Experimental results demonstrate high spatial resolution imaging of natural scenes, with the system exhibiting narrow beamwidth and low sidelobe levels.

Introduction

In the field of remote sensing, high spatial resolution is essential for monitoring Earth’s environmental parameters, such as soil moisture and atmospheric temperature. Traditional "real aperture" radiometers rely on large, mechanically scanned satellite dishes. However, as the demand for higher resolution grows, the physical size and weight of these dishes become impractical for space-borne missions.

Aperture Synthesis Radiometry (ASR) offers a sophisticated alternative. By using an array of small antennas and correlating signals between pairs (creating "baselines"), ASR can synthesize a large aperture mathematically. This process samples the Fourier transform of the scene's brightness temperature, allowing for high-resolution imaging without the need for a massive physical structure.

Topology Optimization and Array Design

The performance of an ASR system is fundamentally tied to its antenna arrangement. The goal is to achieve the most complete coverage of the Fourier plane—the (u, v) plane—using the fewest possible antennas. This leads to the concept of the Minimum Redundancy Array (MRA).

A T-shaped antenna array configuration (left) and its corresponding (u, v) Fourier plane coverage (right).

Optimization Methods

Finding the optimal layout for large arrays is computationally intensive. The authors propose several methods to streamline this process:

  • Restricted Search Method: By exploiting the general structure and repeating patterns found in large linear arrays, this method significantly reduces the search space for optimal configurations.
  • Combinatorial Approaches: Utilizing cyclic difference sets (CDS), researchers can construct 2D arrays (such as rectangular or hexagonal grids) that provide superior sampling compared to standard layouts.
  • Array Thinning: Standard configurations, like uniform circular arrays, often contain high redundancy. Combinatorial theory allows for "thinning" these arrays—removing elements while maintaining the integrity of the (u, v) coverage.
A U-shaped antenna array configuration, often used as a baseline for evaluating sparse array performance.

The HUST-ASR Prototype

The theoretical designs were validated through the construction of the HUST-ASR, a 1-D synthetic aperture radiometer operating in the Ka-band (8mm). The system utilizes a unique hybrid architecture: a sparse linear array of 16 pyramid horns feeding into an offset parabolic cylinder reflector. This design leverages the high gain of a traditional reflector in one dimension while using aperture synthesis to achieve high resolution in the other.

Key Results and Performance

The HUST-ASR prototype demonstrated impressive technical specifications:

  • Resolution: Achieved a synthesized angular resolution of approximately 0.28°.
  • Efficiency: The system reached an aperture efficiency (ηa) of 0.88.
  • Signal Integrity: Measured Voltage Standing Wave Ratio (VSWR) was low (mostly < 1.2), and sidelobe levels were kept below -20dB.

Experimental imaging of a campus scene successfully resolved fine architectural details, such as chimneys and air conditioning units, proving the efficacy of the sparse array design.

Conclusion and Future Work

While the HUST-ASR prototype successfully demonstrates the power of optimized sparse arrays, challenges such as vertical image artifacts and mutual coupling between antennas remain. Future research will focus on advanced error analysis and more sophisticated calibration techniques to further refine the synthetic imaging process.

Reference: Dong, J., & Li, Q. (2010). Antenna Array Design in Aperture Synthesis Radiometers. In: Microwave and Millimeter Wave Technologies Modern UWB Antennas and Equipment. InTech.

Summary updated

Abstract

Antenna array design is an important issue for aperture synthesis radiometers (ASR). In this chapter, two subjects are mainly addressed: one is to optimize antenna array configurations, which determines the spatial sampling performance of ASR; the other is to design the antenna array in the practical ASR system as the performance of the antenna array has much influence on the radiometric imaging performance. The topology optimization of the antenna array in ASR aims to find the minimum redundancy array (MRA), which can provide the most uniform and complete (u, v) coverage in the Fourier plane with the least number of antenna elements and therefore achieves the highest spatial resolution of the image. In this part, different optimization methods and different array configurations for both linear and planar arrays are summarized. And some original work by the authors, including the restricted search method by exploiting general structure of MRLAs and combinatorial methods for constructing thinned circular arrays, is also briefly presented. As a second part of the chapter, a sparse antenna array with parabolic cylinder reflector at millimeter wave band for HUST-ASR prototype is presented. The overall specifications, architecture design, performance evaluation, and measurement results of the antenna array are all detailed. Measured results indicate that the antenna array performs well with narrow main beamwidth, low peak sidelobe level and small VSWR, which are all desired for passive imaging radiometers. Experimental results indicate that the HUST-ASR can generate good images of natural scenes with high spatial resolution provided by the antenna array. Further research will be concentrated on error analysis and calibration of the antenna array in HUST-ASR.
BibTeX
@inproceedings{dong2010antenna,
  author = {Jian Dong and Qing Li},
  title = {{Antenna Array Design in Aperture Synthesis Radiometers}},
  booktitle = {InTech},
  year = {2010},
  doi = {10.5772/9013},
}
Figure